Computer Free Support

How to Make a great setting for BIOS？

First enter the BIOS settings, Different BIOS has different access methods,
Award BIOS: Press “Del” key
AMI BIOS: Press “Del” or ”ESC” key
Phoenix BIOS: Press “F2″ key
Compaq  Press ”F10″ key

Then follow BIOS settings

1, In the Standard CMOS Setup is not connected IDE device in the port of TYPE and MODE set to None.
2, The CPU Internal Cache, External Cache is set to Enabled, open the CPU twelve cache.
3, The System Boot Up speed is set to High. Make the system boot speed for high speed.
4, The Boot Sequence is set to C, A:.
5, Floopy Drive Seek At Boot set to Disable. The startup does not detect the floppy drive.
6, The Above 1MB Memory Test is set to Disabled. Startup does not detect more than 1MB of memory.
7, The Boot Up Floppy seek is set to Disabled. In doing so, to seekthe floppy drive does not start operation.
8, Set the Video BIOS Shadow Enabled. The map on the graphics card BIOS into memory, to improve display speed.
9, The System BIOS Shadow is set to Enabled. The system BIOSmemory mapping to improve performance.
10, The Video BIOS Cacheable set to Enable. So that the BIOS on the graphics card is mapped to the cache.
11, The System BIOS Cacheable set Enbaled. The motherboard’s BIOS is mapped to the cache.
12, The Cache Timing Set Fastset.
13, The SDRAM CAS Latency Time to 3. Set the SDRAM latency. If your memory is not very good quality, set of 3 will greatly reducecrashes.
14, Using the VIA Apollo Pro series motherboard’s BIOS chip has a”DRAM CLOCK” will be its value to HCLK 33, so that your memory will work in the system 33 of the frequency of the FSB, if your CPU is Celeron, that system’s performance will be very obvious, if your memory is to blame, you can be ”DRAM CLOCK” the value is set to”HOST CLK “(system FSB) or” HOST-33 “. Because the Apollo Pro series chip has a unique memory asynchronoustechnology.